SecurityMan PalmWatch II, User Manual

Page: 13 / 20

MANUAL
To select a specific camera on the palm monitor, press the MANUAL button.
The palm monitor will switch to a different camera each time the MANUAL
button is pressed. To avoid searching for channels that do not have cameras
assigned, set the DIP SWITCH (located on the back panel of the palm moni-
tor for those corresponding channels up to the OFF position.
SCAN
Pressing the SCAN button places the system in scan mode. The palm moni-
tor screen blanks into standby mode. The system then continuously scans for
active cameras. If sound is detected above the pre-set sound trigger level of
the baby camera, the palm monitor displays the camera picture and the
beeper alarm will sound. Two minutes after the last detection, the screen
returns to standby/scan mode and the palm monitor resumes scanning.
Pressing the MANUAL or AUTO button will cancel this mode.
VOLUME
The audio volume of the palm monitor can be adjusted by tuning the VOL-
UME tuner on the right side of the palm monitor.
ALARM VOLUME
The alarm volume of the palm monitor can be adjusted by tuning the ALARM
VOLUME tuner on the left side of the palm monitor.
MENU
Press the MENU button on the left side of the palm monitor and observe the
LED status:
-LED on, adjust BRIG/-
-LED flashing, adjust COLOR +/-
-LED off, adjust CO/-
13