SecurityMan PalmWatch II, User Manual, Page: 12 / 20

POWER
• Press to turn the palm monitor ON/OFF.
• When using the battery source on the palm monitor, the built-in LED of the
POWER button will flash to indicate low battery status between 2.5 to 3.5
hours after initial use.
AUTO
Pressing the AUTO button places the system in auto mode. In this mode, the
system automatically rotates through all active cameras. When sound is
above the pre-set sound trigger level of the baby camera, the palm monitor
will display the picture from the camera for a few seconds, and the beeper
alarm will sound. To avoid searching for channels that do not have cameras
assigned, set the DIP SWITCH (located on the back panel of the palm moni-
tor) for those corresponding channels up to the OFF position.
The dwell time (time taken to switch between cameras) is preset to 2 sec-
onds and can be adjusted between 2~30 seconds. To adjust the dwell time,
press and hold both the AUTO & MANUAL buttons simultaneously. Each
flash of the LED increases the dwell time by one second.
12
Auto Power
Manual
Scan
Volume
+
Menu
Alarm
Volume