3
INSTALLATION AND OPERATION
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or Securitytronix at 1-610-429-1511 for
assistance.
3. SPECIAL ATTENTION
a. The installer must comply with electrical safety standards. There must be sufficient
space between the PT Dome Controller and the camera’s communication and power
lines, power supplies and video lines and any high voltage equipment and/or cables.
b. Do not open up or dismantle the ST-PTZ-RC or the PT Dome Controller’s cases.
There are no serviceable parts inside the unit.
c. Do not install ST-PTZ-RC or the PT Dome Controller in an environment where the
temperature is above 104
°
F.
d. Do not install the ST-PTZ-RC or the PT Dome Controller in a damp environment.
e. Only use a dry cloth to clean the units. If there is dirt that is difficult to remove wipe
gently with a mild detergent. Never use strong or abrasive detergents.
f. A minimum 12VDC 1A power supply must be used. AC power cannot be applied.
Using an AC or other incorrect power supply will damage the unit. The SecurityTronix
ST-PS12VDC1A power supply is recommended.
g. Only qualified installers are allowed to install, test and disassemble the ST-PTZ-RC
and the PT Dome Controller.
h. As the ST-PTZ-RC and PT Dome Controllers are sensitive devices any shock or
collision to the units or shaking of the units will cause damage and void the warranty.
4. PRODUCT PICTURES
