6
Set HOME Position
a. Setting the HOME position is very similar to setting Preset Positions.
b. Using the
LEFT/RIGHT
and
UP/DOWN
buttons move the camera to the desired
Home Position.
c. Press
PRESET
and hold for 3 seconds.
d. Press
HOME
followed by
ENTER
to confirm.
Set A and B Limiting Positions
a. Setting the A and B Limiting Positions is very similar setting Preset Positions and the
HOME position.
b. Using the
LEFT/RIGHT
and
UP/DOWN
buttons move the camera to the desired A
Position.
c. Press
PRESET
and hold for 3 seconds.
d. Press
A
followed by
ENTER
to confirm.
e. Repeat the above steps for the
B
Limiting Position.
Delete HOME and A and B Limiting Positions
a. Press and hold
DELETE
for 3 seconds. The PT Controller’s screen will display
b. Press
HOME
,
A
or
B
followed by
ENTER
to confirm.
Set Up and Run Pattern Tour
A Pattern Tour allows the camera to automatically track a select group of Preset Positions.
a. Pressing
PATTERN
once puts the ST-PTZ-RC into Pattern
Track Setup Mode. The PT Dome Controller will display
b. In the setup mode up to 16 pre-existing Preset Positions
can be selected. For example, if the camera is to tour Preset Position 6, Preset
Position 2, Preset Position 3 and Preset Position 8:
Press
SHOT
,
6
,
ENTER
Press
SHOT
,
2
,
ENTER
Press
SHOT
,
3
,
ENTER
Press
SHOT
,
8
,
ENTER
d. It is possible to set both the camera movement speed from one Preset Position to
another as well as the dwell time the camera stays on a Preset Position. See “Set
Speed” below for details.
e. To end the Pattern Track Setup Mode press
PATTERN
and
the PT Dome Controller will display
CLr-
PStA
PStO
