3
INSTALLATION AND OPERATION
CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this
unit. No user serviceable parts are inside.
CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than
specified power source.
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for
assistance.
3. SPECIAL ATTENTION
a. The installer must comply with electrical safety standards.
b. You must use the correctly rated power supply. A 12VDC 10A power supply is
included. Use of any other power supply may damage the unit.
c. Only qualified installers are allowed to install and test the power distribution box.
d. This unit is designed for INDOOR USE ONLY.
4. INSTALLATION
a. Mount the cabinet in the desired location.
b. Slide the switches to the OFF position.
c. Connect each device (e.g., CCTV camera) to the individually protected outputs
(terminal pairs “Common Power Outputs” and “Fuse Power Output”)
d. Plug the power supply into an appropriately rated AC outlet (100-240VAC, 47-63Hz).
e. Slide the switch for each 9-port bank to the ON position.
f.
When the unit is powered up the GREEN AC LED should be on.
Troubleshooting assistance can be found on-line at
www.securitytronix.com
in addition to support
from SecurityTronix sales engineers at 1-610-429-151
This symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a
risk of electrical shock.
