Step 1
Take the installation position map from the accessories bag and them put it on
the surface of the ceiling or the wall according to the cable exit position. Dig
three holes according to the installation position map and then take three ex-
pansion bolts from the accessories bag and put them to the holes you just dug.
Step 2
Use inner hex wrench to remove the three enclosure fastening screws and then
remove the dome enclosure.
Step 3
Adjust the pedestal position according to the cable exit move(ceiling/side).
Pull the cable through the cable side exit at the installation surface and the
pedestal (Please skip this step if you want to use ceiling exit mode). Line up
the screw holes at the bottom of the pedestal to the expansion bolts in the in-
stallation surface. Put three self-tapping screws to expansion bolts and then
secure firmly. Now the pedestal is on installation surface.
Step 4
Adjust the camera module angle to a proper position and then fix the screws
to fasten.
Step 5
Use three enclosure fastening screws to secure the dome housing on
the pedestal.
Fastening Screw
