NEED HELP
Call
(972) 474-6390
We are available
Mon–Fri
/
8am–5pm Central
© 2020 Security Brands, Inc. All rights reserved.
QSG-14RTE300-EN Rev. A (5/2020)
2 of 2
Model
14-RTE300
Q U I C K S TA R T
G U I D E
RTE 300
6
Make sure gate/door path is clear;
then press exit button on RTE unit
and con
fi
rm gate/door opens.
(If nothing happens, go back to
Step 5
)
4
Locate receiver (not included) and
open for access to DIP switches.
NOTE: For a gate installation, the receiver is typically
installed inside the gate operator housing.
NOTE: Key switch must be in the “enabled” position.
1
2
3
4
5
6
7
8
9
0
ON
1
2
3
4
5
6
OPEN
7
8
9 10
RTE Unit DIP Switches
Receiver DIP Switches
(look of components may vary)
5
Carry RTE unit to receiver; then set DIP switches on RTE unit to
match DIP switches on receiver. Double check for match.
1
2
3
4
5
6
7
8
9
0/10
Unit Enabled
(exit button active)
Unit Disabled
(exit button inactive)
A
The RTE unit can be disabled or enabled at any time using the
key switch located below the exit button.
NOTE: Use the blanks above to note positions. Use an “X” for ON and leave blank for OFF.
DIP switches may be labeled di
ff
erently. The word, OPEN, means the same thing as OFF.
Your system is ready to use.
INSTALLATION COMPLETE!
N
IMPORTANT!
r
The RTE 300 is compatible
ONLY
with
300-MHz RECEIVERS
that use
10 DIP SWITCHES
, including those with
the Digi-Code or Multi-Code
®
brands.
This unit
WILL NOT WORK
with any
other receivers!
If you are not sure what kind of receiver
you have, check with your distributor.
