securio P 44, Operating Instructions Manual

Page: 19 / 200

09/2015
SECURIO P 44
19
english
6 Cleaning and maintenance
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
8 Scope of delivery
• Paper shredder, ready for connection, in car-
ton packing, carton on pallet, tied with strap-
ping tape
• 5 bags for shredded material
• Special cutting block oil (cross cut)
• Operating instructions
Acces so ries
• 25 bags for shredded material,
order No.: 1.452.995.000
• Special cutting block oil 250 ml,
order No.: 1.235.997.403
See page 202 for our customer service
addresses.
Clean the document shredder only with a soft
cloth and a mild soap-water solution. However,
no water must enter the equipment.
Strip cut only:
Oil the cutting unit when
cutting performance
decreases or the device
becomes noisy, or every
time you empty the waste container. Only use
HSM special lubricating oil for the cutting unit to
do this:
• Spray the special cutting unit oil through
the paper feed along the entire width of the
cutting shafts.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any
paper.

Paper dust and particles are shaken off.
WARNING
Dangerous mains voltage!
Improper handling of the machine can lead to
an electric shock.
Switch the shredder off before
relocating or cleaning it and
disconnect the mains plug.
Service work which requires the
housing covers to be removed may
only be carried out by HSM Cus-
tomer Service and service techni-
cians of our contractual partners.
See page 202 for our customer service
addresses.
PAPERcontrol
The measuring of the paper thickness is regu-
larly calibrated: the LED fl ashes for a short time
after 400 seconds.
http://www.monomachines.com/
http://www.monomachines.com/