Securimax smart-vent colourtouch, User Manual

Page: 22 / 40

19
CLImate
CLIMATE
SeTTINgS ClIMATe is the defining
setting for the control over your
home comfort. Some modes are
dependent on this temperature
range being setup such as the Heat
Transfer and Tempering Heater.
The reset values for ClIMATe are:
Maximum Temperature = 30°C
f
Minimum Temperature = 5°C
f
System Maximum Temperature
If the temperature exceeds the
maximum temperature the following
will happen
a) Outside air is vented into the house (if
the summer feature is installed).
b) The fan turns off when Fan Mode is
‘enabled’ (non summer models), to stop
hot air entering the home. (Page 26)
for
more information)
System Minimum Temperature
If the temperature falls below the
minimum temperature the following will
happen
a) Fan speed drops to speed 1 (no heater
is installed)
b) Fan speed drops to speed 2 (heater
installed and enabled)
c) Fan Speed drops to speed 1 (heater
installed and disabled).
If the temperature falls in between
the Maximum and Minimum then the
system is running Normal
Note: The controller will not allow the
minimum temperature to be set greater
than the maximum or vice versa
Clock
Heater
Fans
Heat Trans
S
E
T
T
IN
G
S
Climate
CLIMATE
Min Temp: 15°C
Max Temp: 26°C
?
In SeTTINgS Press ClIMATe and the
page will display
The Minimum Temperature setting
is highlighted to indicate that this is
the active setting. Use the
arrow
to decrease and the arrow to
increase the temperature to your desired
level.
Press Maximum Temperature and then
the and arrows to increase/
decrease the setting as desired.
The ClIMATe tab is highlighted with a
blue border to indicate that this is the
active page.