13
Heater
HEATER
An information page providing the
status of your heater (if installed),
showing whether the heater is ON
or OFF and (if ON) which of the 3
modes (Normal, Override or Timer)
is active. This information reads
directly from your settings in the
SYSTeM HeATeR pages (refer to
page 21 to set these up).
To access Smart-Vent HeATeR press the
Heater tab on the SYSTeM Menu page:
S
Y
S
T
E
M
Heater
Contact
Filter
?
HEATER
To change these settings press the Flame on
the right or go back to the ‘Settings’ menu
and press ‘Heater’.
Heater currently:
ON
Mode:Normal
Heater
ENABLED
In this example, the heater is enabled
and active (ON) and operating in
Normal
mode, which means the heater turns ON
when the ceiling temperature falls below
your minimum temperature setting.
?
HEATER
To change these settings press the Flame on
the right or go back to the Settings menu
and press ‘Heater’.
Timer 1
ON
06:15 - 09:00
Timer 2
ON
17:30 - 22:30
Heater
ENABLED
Mode:Timer
In this example the heater is in
Timer
mode with it programmed to turn ON
at 6:15hrs and OFF at 9:00hrs on Timer
1, and then ON again at 17:30hrs and
OFF at 22:30hrs on Timer 2, provided
the room temperature is below your
minimum temperature setting.
and a HeATeR page will appear: Shown
below are samples of possible heater
pages:
?
HEATER
To change these settings press the Flame on
the right or go back to the ‘Settings’ menu
and press ‘Heater’.
Heater
DISABLED
In this example the heater has been
‘disabled’ which means under no
circumstances will the heater turn on.
Summary of Contents for smart-vent colourtouch
Page 1: ...USER MANUAL the SMART way to Ventilate your Home ColourTouch Screen Controller...
Page 2: ......
Page 20: ...17...
