INSTALLATION
MOUNTING:
1. The Securview™ OEM-6309 Rear Vision System uses a wide-angle lens for best all around
performance. The Camera will display the full width of most parking spaces up to 8 feet or
even wider.
2. The OEM-6309 is design to be mounted on the License Plate bezel of a Toyota Camry
vehicle. If you wish to mount this camera on any other vehicle, double check the mounting
location to see if the camera will fit on your vehicle in your location of choice.
3. Locate the factory camera mounting location which is usually to the right or left side on the
license plate bezel above the license plate
4. Route the wiring harness into the vehicle. There may be an existing factory rubber grommet
that you can use to run the wiring into the trunk area. If you have to drill a hole, make sure to
double check behind the drilling location before drilling. Once the hole is drilled and the wiring
is run into the vehicle, seal the edges of the hole with silicon or caulking to prevent moisture
damage.
5. Snap the camera securely into place in the mounting location.
SIDE VIEW
License Plate
Camera Lens
Mounting
Surface
Cable
CAMERA
CAMERA:
1. The color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.
2. This camera is designed to work well in day time or night time conditions.
3. The camera is completely electronic. There are NO manual adjustments for focus, etc.
