Rev. 20190204A
To
9 of 25
D
ISABLING THE
T
IMEOUT
L
OCK IN
U
SER
M
ODE
Follow the same steps for setting the Timeout Lock (above) and enter
00
for the time
delay.
The Timeout Lock is now disabled.
Admin Mode
When unlocked with and Admin PIN the USB KP is in
Admin Mode
. Admin Mode is
especially useful for corporate deployment and it can be used to ensure policy. For
example:
•
Recovering data from a USB drive and creating a new User PIN in the event
that you or an employee has forgotten the User PIN.
•
Retrieving data from a USB drive if an employee leaves the company.
•
Setting policies such as ‘Read-Only’ or ‘Time Out Lock’
•
The Admin PIN can be used to override all User settings
Button Pressing Conventions
Many Admin procedures start with pressing and holding a number button down (
1
or
7
,
for example) and while holding it, pressing
button: abbreviated in the steps below as:
Press and hold down
7-and then press-
.
In some cases, you must hold down the number while pressing and releasing
button
twice: abbreviated as:
Press and hold down
1-and then press-
.
NOTE:
All procedures under this heading start with the USB unplugged from a
computer.
NOTE: Each step in all procedures listed below has a 10 second window to start the step
after it. In general, a blinking LED times out after 10 seconds.
The PIN requirements are the same as User-Mode. Refer to
page 5.
Admin PINs
CAUTION
: Risk of loss of data. If you forget your User PIN and no Admin
PIN exists, or you forget both PINs, all data will be inaccessible and
reformatting will be required.
