Rev. 20190204A
To
5 of 25
PINs and Procedures
PIN
R
EQUIREMENTS
Your User PIN or Admin PIN must:
•
be between 7-15 digits in length
•
not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
•
not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7),
(7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
NOTE: Creating words (using the corresponding number key for each letter) can be more
memorable than a string of numbers.
P
ROCEDURAL
C
ONVENTIONS
•
All procedures must be performed prior to inserting the USB KP into a
computer
.
•
The LED status shown in these procedures is what you should see after
performing each step.
•
Unless otherwise noted, all procedures start with the USB locked.
•
In this manual,
means press the key button twice;
means
press it three times.
NOTE: Each step in all procedures listed below have a 10 second window to start the
next step. In general, a blinking LED times out after 10 seconds.
After unlocking the USB, it will lock again if not inserted into a computer within 30
seconds.
Cancelling a Procedure
To cancel most procedures prior to finishing, press and hold
for six seconds. The
exception are procedures for setting options (
) which you can just let time
out between steps.
User Mode
New USBs are shipped with a default User PIN which is 11223344 (otherwise, your
vendor will supply it). We strongly recommend changing the password once it is
unlocked.
