SECOMP ROLINE ProSecure II 1000 VA, User And Installation Manual

Page: 50 / 58

20
Button Operation
Please note the three operating buttons on the front panel:
1. “ ” is a ON/ OFF button :
(a). Push the “ ” button (at least 3 seconds) to turn on the UPS.
(b). When UPS is working, the ” button (at least 3 seconds) to turn off the UPS.
2. “ ” is a Enter button. Use this button to check content of UPS and the method is listed below:
(a). Push the ” button (at least 2 seconds) to check content of UPS. Each content can be displayed
by pressing at once, and it has fifteen kinds of function to be checked.
(b) If no pressing within 10 seconds, it will return to original status.
3. “ ” is a Function button . Each function can be enabled by pressing this button.
(a). Push the “ ” button (at least 2 seconds) to choose which function that you want.
Each content can be displayed by pressing at once, and it has fourteen kinds of function to be
checked.
(b). After choosing the function, push the “ ” button to enter the function that you want.
(c). Push the “ ” button to choose other function again.
(d). Push the “ ” button to enable your function.
(e). Push the “ ” button to confirm and enable your function.
(f). If no pressing within 10 seconds, it will return to original status.
Control Panel functions
Operation of the UPS is indicated on the monitor panel with five LED indicators and an LCD screen. This display is also
capable of alerting the user with audible alarms.
ON/ This green LED is lit when UPS has been turned on.
ON-LINE/ When the UPS is in normal or static bypass modes, there is voltage at the output terminals and this
LED will light up in green.
ON-BAT/ While operating in battery mode.
BYPASS/ While operating in bypass mode, this LED will light up in yellow.
FAULT/ If any internal error occurs in the UPS, this LED will light up in red and give off an audible alarm. Press any
of the buttons on the front panel to turn off the alarm.