SECOnITX-ION
User Manual
- Rev. First Edition: 0.1 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.M.
Copyright © 2011 SECO s.r.l.
SECOnITX-ION
pag. 45
MCP Serial UART
Disabled
3F8/IRQ4
2F8/IRQ3
Leave this option Disabled, to prevent PCI bus
malfunctioning
Restore on AC Power Loss
Power On
Power Off
Last State
This option allows to determine how the board must act
after a Power Loss:
if “Power ON”, the board will start every time the power
supply is present;
if “Power OFF”, the board will not start automatically
when the power supply returns.
If “Last State”, the board will start again when the power
returns if it was ON, and will remain OFF if the board
was in this state when the power went down.
C2 Popup
Disabled
Enabled
This option allows to enable the popup to C2 state in
case of busmastering activities during C3 and C4 states
Power Saver
See Submenu
4.7.2.1 Power Saver submenu
MENU ITEM
Options
Description
SATA PM Override
Disabled
Enabled
SATA Low Power State
Disabled
Partial
Slumber
P Slumber
This option allows to select which level of power Saving
is allowed when there is no I/O on the disk if a medium
power level (Partial, good for a small impact on
performances) or a minimum power level (Slumber,
optimal for long idle periods expected) or both
AHCI Aggressive Link Mode:
Disabled
Enabled
When enabled, this option allows the disk to save
power, by setting a SATA link to the disk to a low-power
setting during idle time (i.e. when there is no I/O).
SATA Clock Ratio
0, 1, 2, …, 16
Enter numeric value
SATA Clock Select
133MHz
200MHz
Sets SATA clock speed
