Sebo 90406AM, Owner'S Manual

Page: 12 / 16

TROUBLE-SHOOTING GUIDE
PROBLEM
Does not turn on
or machine shuts off
intermittently
Bag full or clog light on
or flashing &
machine shuts off
(red light A see page 9,
figure 7, also, see page 4)
Brush light on or flashing
(red light B see page 9,
figure 7, also, see page 4)
Brush light flashing &
machine shuts off
(red light B, page 9, also,
see page 4)
Does not pick up
Front bag door won’t
fully close
Hose doesn’t retract
after cleaning wand is
inserted
REASON
1. Handle not fully inserted into the bag
housing, causing a faulty connection.
2. Not plugged into good outlet.
3. Cable worn.
4. Bag housing (6) not seated fully
into proper “locked” position
on top of power head.
1. Bag full.
2. Clog in airflow pathway, attach-
ment hose, cleaning wand, swivel
neck or entrance to filter bag.
3. Microfilter dirty.
1. Brush worn.
2. Incorrect brush setting
1. Brush jammed or clogged.
2. Brush is too low for the surface
being vacuumed.
1. Cleaning wand not correctly
inserted.
2. Front cover not closed.
1. Cover release flap not fully closed.
2. Bag not inserted properly.
3. Microfilter not properly inserted.
1. Cleaning wand not properly
inserted.
SOLUTION
1. Release handle catch, push handle
down, close handle catch.
2. Use another outlet.
3. Replace cable.
4. Housing release button (8) should
be snapped outward to its locked
position.
1. Replace bag. See page 10.
2. See Clog Removal on page 11.
3. Replace microfilter. See page 10.
1. Replace brush. See page 10.
2. Adjust the brush by turning the pile
adjustment knob up or down.
1. Clear jam. See page 11.
2. Raise the brush by turning the pile
adjustment knob up.
1. Reinsert cleaning wand, making
sure lower end of tube is in the
lower hole and handle is properly
seated over the projection tab (23).
2. See below.
1. Reinsert bag. Lock the cover
release flap down firmly.
2. Reinsert bag with cover release
flap (5) up, until firmly latched in
bag holder (see pg. 10, figure 9).
3. Lift safety lever and insert filter with
vertical plastic ridge on filter facing
you (see pg. 10, figure 10).
1. Reinsert making sure top of handle
is pointing back and tube is fully
seated on the protruding tab (23)
on top of the bag housing.
Always unplug vacuum from outlet before dismantling any part of the machine!
!
12