Commissioning the logger
24
Step Description
4
Insert the SIM card.
To remove the tray for the SIM card from its fastener, press the yellow spring
mechanism (e.g. by the help of a screwdriver or a pen). Remove the tray and
place the SIM card on it so it fits. Then push the tray back into the bracket until it
locks into place.
5
Attach the cover to the housing again.
The rubber seal inside the cover is not glued in and may possibly fall out.
Therefore, when re-assembling the device, it may be helpful not to put
the cover on the housing but to take both parts upside down and then put
the housing on the cover.
Note the following points when assembling.
•
The rubber seals and the housing and cover surfaces which touch each other
must be free of dirt.
•
Do not pinch the wires of the batteries!
•
Do not jam cover when putting it on the housing!
•
Tighten screws crosswise!
•
Carefully tighten the screws finger-tight! Do not overtighten!
The logger has no internal or external antenna. To enable the GSM connectivity the
delivered external GSM antenna must be connected to the device.
Connect the antenna to the
GSM
socket
. Make sure that the guide on the plug fits in
the groove in the socket and that you feel the plug latch in.
Connect GSM antenna
Summary of Contents for Sebalog D-3
