Programming the logger using the SebaDataView-3 software
63
8.6
Configuring the mobile communication
If your logger is equipped with an internal GSM modem, data transfer and alarm
messaging via mobile radio can be realised. For this purpose, a UMTS-enabled SIM
card (data contract) is required which can be obtained from almost any local mobile
network operator.
Usually, all the data required to set up mobile data transfer is provided within the
mobile network contract. Further information can be obtained from the website or
the hotline of the mobile network operator. If necessary, request guidance for
setting up data communication in particular. SebaKMT cannot provide any
specific technical advice in this case.
For mobile communication a number of settings must be made. Proceed as follows:
Step Description
1
Make sure the logger has been properly prepared for GSM connectivity (see
page 23).
2
In the
Communication
segment of the window, tick the
GSM active
checkbox.
3
Click the
Configure GSM
button.
Result:
The GSM configuration dialogue appears.
4
Enter all the requested data. (You find more information about the configuration
dialogue below in the text).
5
Click
Test
to perform a GSM test. This test checks the existence and quality of
the cellular connection. (You find more information about testing the GSM
connection below in the text).
6
Confirm and save the settings by clicking the
OK
button.
Introduction
Procedure
Summary of Contents for Sebalog D-3
