4
Operating instruction
ST60-Wireless is designed to work normally without any operation. At delivery the ST60
Wireless ist "ready to use"
Exeption: when a unit is exchanged, transmitter and receiver have to be synchronised in the
"Learn mode" (see instruction below)
The receiver contains 7 LED's to sho
w
th
e
rel
ev
an
t
da
ta.
4.1 LED display
RxD
green
received data. Receives ST60-Wireless protocols
short flash:
received protocol, but not meant for this device
long flash:
received protocol, identified for this device
TxD
yellow
transmission of a ST60-Wireless protocol
short flash for each outgoing protocol
RxErr
red
receiver- or communication error
short flash:
receiption of any data or HF inputs
This LED shows reliably, if the "air is clean" from other HF-desturbing signals.
At intensiv flickering of this LED, the source of desturbance should be eliminated or the
receiver should be better placed.
long flash:
reception of a corrupted protocol or protocol synchronisation error
ST60- Wireless
Owner's Handbook
Doc:
ST60_Wireless_Manual_E_V10
LastEdit:
03.02.2005
Printed:
03.02.2005
page 7
- 20
RxD
TxD
RxErr
Battery
Data
Error
received data
transmition of data
receiver/communication error
battery level of the transmitter 1)
received masuring data from transmitter 1)
disturbance/defect of transmitter or receiver
display of the system status
status / control button / learn mode
1) by receivers with the S/N X.1.1xxx are this two
LED's exchanged