5
Fig14
可以拿出搅拌器直接用水清洗；
Take out the mixing shaft, clean by water directly;
Fig15
奶泡机杯体可直接用水清洗；
The cup could be immersedin water for cleaning
Fig16
不能将奶泡机机座用水直接喷淋；
Can not spray the power base by water directly;
Fig17
不能将奶泡机机座放入水中清洗；
Can not clean the power base in water;
Fig18
奶泡机机座底部存放有备用搅拌器。
There are two spare mixing shafts
问题分析
Failure Analysis
1.
上图，当按键出现红色报警灯，是指奶泡机
NTC
温度传感器未接或者短路，或温度超过
115
°
C
。
In the figure above, when the button is red, it means the NTC temperature sensor is not connected or
short-circuited, or the temperature exceeds 115 ° C.
2.
按下按键后，指示灯不亮，奶泡机不工作，可能要继续进行如下检查：
Press the button, the light doesn't shine, milk machine does not work, may need following checks:
a.
如果是电源线损坏，必须由制造商或经销商或其他指定的维修点或类似部门的专业人员更换，以避免
发生危险。
If the cord were damaged, it must be replaced by a manufacturer or a dealer or other appointed
agent service station or equivalent personnel in order to avoid danger.
b.
检查电源插座上输出电源是否正确，检查电源插头与插座是否插紧。如果还不能解除故障，请联系具
备专业的维修部门。
Check the power outlet is correct, check the power plug and socket plugged well or not.
If the problem can not be solved, contact a qualified service agent.
3.
如果牛奶不形成牛奶泡，请检查搅拌器是否正确；检查搅拌器是否放在杯体下部中轴的正确位置；检查搅
拌器是否损坏；检查搅拌器是否被其它东西或者是旧的残渣堵塞；或更换新的搅拌器。
If the milk does not
frother a milk bubble, check the mixing shaft is correct or not; check whether the mixing shaft on the spindle
properly; Check the mixing shaft damaged or not ; Or replace a new mixing shaft.
制造商：宁波西文电器有限公司
Manufacturer: Ningbo SEAVER Electric Appliance Co., Ltd
电话
TEL
：
0574-62763858
