Communication
21
Controls and equipment
instructions for completing this operation should be found in the instruction
manual for the telephone.
The final step for establishing the connection is the introduction of the PIN
code into the hands-free system (initially 1234). If you would like to change
the PIN code for the SEAT_UHV system then contact an official SEAT work-
shop. Once the PIN code is input then the connection is established and the
system can be used with the Bluetooth system. The moment that the connec-
tion is established, the hands-free kit will emit an acute sound.
Once the initial configuration process is finished, each time the telephone is
within range of establishing a Bluetooth connection with the hands-free
system this will be done automatically as long as the ignition is on and
without any need to configure the connection further.
The connection between the telephone and the hands-free system will not be
established if this system is already communicating with another phone.
If there are two or more Bluetooth telephones within communication range of
the hands-free system then the system will connect with the one that was
most recently connected.
WARNING
•
When your mobile phone establishes a connection with the hands-free
system, it emits both a visual and audible signal.
•
It should be noted that when driving at night with the radio off, the
visual signal involves the screen lighting up for approximately 3 seconds.
Note
It is important to personalise the device PIN code using a personal 4 digit
code. Consult an official SEAT workshop.
Radiophones and business equipment
Radiophones and fixed installation business equipment
Radiophones
Any retrofit installations of radiophones in the vehicle require prior approval.
SEAT generally authorises in-vehicle installations of approved types of radio-
phones provided that:
•
the aerial is installed correctly,
•
the aerial is installed on the exterior of the vehicle (and shielded cables
are used together with non-reflective aerial trimming),
•
the effective transmitting power does not exceed 10 Watts at the aerial
base.
Your Authorised Service Centre will be able to inform you about options for
installing and operating radiophones with a higher transmitting power.
Business equipment
The retrofit of domestic and business equipment is permitted provided that
these do not have an effect on the concentration of the driver and that they
are
CE
approved. Equipment retrofitted to the vehicle that may have an effect
on the concentration of the driver must come with a specific licence for this
type of vehicle and with the symbol
CE
Note
•
The posterior fitting of electric and electronic equipment in this vehicle
affects its licence type and could lead to the withdrawal of the vehicle regis-
tration document under certain circumstances.
•
We would request that you pay special attention to the instructions
regarding the use of mobile telephones and radio transmitters.
Sist Comunicacion_ing Seite 21 Dienstag, 13. März 2007 5:30 17