Communication
11
Controls and equipment
Control commands
The control commands are used to carry out functions that have already been chosen.
The control commands are used during or at the end of a dialogue to carry out
certain functions.
Possible commands
Dial number
A telephone number can be vocally specified to the system and then dialled.
– Press the talk button
. Activation of the system is confirmed
with by a tone.
– After the tone, say the command
DIAL NUMBER
.
After this command the system will then request that you specify a telephone
number. A connection will then be established to the specified number. The
telephone number can be specified all at once, in blocks of digits (separated
by a brief pause), or as single digits. You can specify the digits from
0
to
9
.
After each block of digits you specify (separated by a brief pause) the system
Speech command
Effect
DIAL
Telephone number already entered is dialled.
STORE
A name is saved in the phonebook with its phone number
CANCEL
Cancels a running dialogue.
REPEAT
The specified name or all of the digits specified up to this point will be
repeated. The system will then give the cue
<Please proceed>
so that you can
specify additional digits or commands.
CORRECTION
The specified name or the last entered block of digits will be deleted. The sys-
tem will then give the cue
<Please proceed>
so that you can specify additional
digits or commands.
ERASE
All specified digits will be deleted. The system will then give the cue
<The
number is deleted. The number, please?>
so that you can specify new digits or
commands.
Sist Comunicacion_ing Seite 11 Dienstag, 13. März 2007 5:30 17