P3
Motor Placement
The motors are to be located on both sides
of seat back leaving the spine area open. It is
recomended that a set of motors are located
below the belt line and then stacked. The
motors should not be positioned in the
shoulder blade, neck or head area. To
begin the installation, locate the
massage areas and mark the positions
(tape) while sitting on the seat. This will
reference the locations when the cover
is removed.
1. Locate motor placement on seat back.
2. Remove seat cover and locate and verify motor placement.
3. Trace the motor on the foam, cut out the foam and set motor in cavity
4. Pass the motor wire through the foam and attach to the distribution box.
5. Connect all wires and test the system and motors
6. Adhere motors into the foam
7. Place 1/4" foam over the motors and cavity if necessary
8. Instal the connection box into the seat back and tie any loose wires.
9. Check placement of boxes as not to interfere with lumbar/recliner
10. Run power wire to 12 volt supply and test system
11. Re-cover the seat back.
12. Place control wand in vehicle and test
Options:
3A. Cut a slit into the foam, create a cavity with your fingers and slip motors into place.
This may create a lump in the foam but it will enhance the massage effect
21
20
30
31
40 41
