Massage System Parts List
P2
The Reviltalzer Massage System is a vibration system that has been designed
to be installed into the seat back foam in a minimal amount of time with readily
available tools. The unique design allows the driver and passenger to experience
revitalizing massage in the Lumbar area in almost all of today's vehicles.
GENERAL ADVICE:
- The Revitalizer is to be installed into the back foam. Always check the motor
placement on the seat prior to beginning any work. Make sure there are no
obstacles that would not allow the motors to be installed.
- Check for Occupant Detection System in the seat back prior to installing.
The system cannot be installed under an Occupant Detection System.
- The installer is liable for any damage due to improper installation.
- All steps explained in this manual are to be followed with great care.
- Installation has to be performed by qualified personnel only.
- Improper installation will void the limited warranty provided by the
manufacturer and may cause physical damage to equipment or people.
- The massage system has to be connected to 12 volt accessory power and
draws a maximum of 2 Amps continuous current.
- The wire harness has to be fitted to the seat in a way that the full range of
movement of the seat is possible without damaging the wire harness.
- Cars fitted with side airbags have to be treated according to the manufacturers
fitting manuals. The massage system is only to be attached to the middle of the
seat back foam.
Important Safety Instructions
Motor set - 6 pcs
Connection box - 1 pc
Wand with curly cord - 1 pc
Power wire -1 pc
H/T
P/W
41
40
20
31
30
21
Fuse
Red Line:
Black Line :
-
+
Connect Box
