ASSEMBLY
12
CHECK THE TIRES
The tires were over inflated for shipment. Check the tire
pressure in the tires. See the sidewall of the tire for the
proper inflation.
IMPORTANT! BEFORE YOU START
OPERATING
Check the fasteners. Make sure all fasteners are
tight.
On electric start models, the unit was shipped with
the starter cord plugged into the engine. Before
operating, unplug the starter cord from the engine.
NOTE: This snowthrower was shipped WITH OIL in the engine. See “Before Starting Engine” in-
structions in the OPERATION section of this manual before starting engine.
SNOW CHUTE ASSEMBLY
1.
Position the snow chute onto the snow chute flange. Al-
ign the three holes in the snow chute with holes in snow
chute flange (see Figure 7).
as shown in Figure 7 (hardware is found in parts bag).
3.
Place
on outside of flange.
4.
Tighten all carriage bolts securely.
NOTE: DO NOT overtigten carriage bolts.
Figure 7
Chute Extension
Snow Chute Deflector
Nut
Flatwasher
Flange
Carriage Bolts
Not
for
Reproduction
