F. REMOVING STIRRER FAN
(Figures 16 and 17)
(1) Remove one rivet ASS'Y securing it to the oven
upper plate by using knife blade.
(2) Pull out the stirrer fan cover.
(3) Remove two rivets ASS'Y securiting it to the oven
upper plate by using knife blade.
(4) Remove the stirrer fan.
G. REMOVING DOOR (Figure 18)
(1) Remove the vent grille by two screws securing it to
the outcase loosening.
(2) Disconnect two leadwires.
(3) Lift up and draw the door.
H. DISASSEMBLING DOOR (Figure 19)
(1) Remove the dielectric choke by using knife
blade or small screw driver, etc.
(2) Remove two screws securing it to the door handle.
CAUTION: Be careful not to damage door seal
plate with the screwdriver.
NOTES:
•
After replacing the door, be sure to check that the
primary interlock switch, the secondary interlock
switch and the interlock monitor switch is in good
operating normally.
•
After replacing the door, check for microwave energy
leakage with a survey meter. Microwave energy
leakage must be below the limit of 5mW/cm
2
. (With a
275 ml water load)
7-8
Door Screen
Figure 17
Figure 16
Figure 19
Figure 18
Summary of Contents for 721. 63762
