18
| 008 Sears CA Treadmill Service Manual [rev 1.0]
Section Two |
Resetting The Incline Motor
>>
Resetting the Incline Motor after replacing the Motor Control Board
Tools Required:
• Phillips Screwdriver
• 17mm Socket
• 17mm Combination Wrench
Procedure:
1 |
Turn off power to the treadmill and unplug power cord from wall outlet.
|
Replace the Motor Control Board.
|
Fold treadmill into locked position.
|
Undo bolt that attaches the elevation tube to the bottom of the machine (
F1
).
F1
F
|
Power up the machine and let the incline spin freely in the tube until it reaches its “zero” position,
and then turn power off.
|
Spin shaft manually until it is almost flush with the incline motor casing and only about 1 thread is
visible (
F
).
7 |
Reinsert bolt and power up the machine.
8
| Test the incline function and calibrate the unit.
17 mm Bolt
17 mm Nut
Proper Zero
Shaft Position
