Yukon HX Motherboard User Manual
4
(Continued)
Error Message
Explanation
Display Switch Not Proper Some systems require a video switch be set to
either color or monochrome. Turn the system off, set
the switch properly, then power on.
DMA Error
Error in the DMA Controller.
DMA 1 Error
Error in the first DMA channel.
DMA 2 Error
Error in the second DMA channel.
FDD Controller Failure
AMIBIOS cannot communicate with the floppy disk
drive controller. Check all appropriate connections
after the system is powered down.
HDD Controller Failure
AMIBIOS cannot communicate with the hard disk
drive controller. Check all appropriate connections
after the system is powered down.
INTR1 Error
Interrupt channel 1 failed POST.
INTR2 Error
Interrupt channel 2 failed POST>
Invalid Boot Diskette
The BIOS can read the disk in floppy drive A:, but
cannot boot the system with it. Use another boot
disk and follow the screen instructions.
Keyboard is
Locked...Unlock It
The keyboard lock on the system is engaged. The
system must be unlocked to continue to boot.
Keyboard Error
The keyboard has a timing problem. Make sure a
Keyboard Controller. AMIBIOS is installed. Set
Keyboard is Advanced Setup to Not Installed to skip
the keyboard POST routines.
Keyboard / Interface Error There is an error in the keyboard connector.
No ROM BASIC
Cannot find a proper bootable sector on either drive
A: or C:. AMIBIOS cannot find ROM Basic.
Off Board parity Error
Parity error in memory installed on an adapter card
in an expansion slot. The format is:
OFF BOARD PARITY ERROR ADDR = (XXXX)
XXXX is the hex address where the error occurred.
Run AMIDiag to find and correct memory problems.
continued
*
