Latest products and information available at www.sealite.com
31
SL07, SLC310 & SLC410
Compact 3-5nm+ Solar Marine Lanterns
How to Change the Regulator (SLC310 & SLC410 Models)
1.
Remove the 4 x M6 x 20 socket head cap screws and 4 x M6 nylon washers, then disconnect the
light head from the chassis.
2.
Remove the 2 x M4 x 20 socket head cap screws, 2 x M4 spring washers and 2 x M4 penny
washers then remove the upper battery bracket containing the regulator
.
3.
Disconnect the battery.
4.
Take note of the wire colours and location in the regulator.
5. Disconnect the wires from the regulator.
6. Remove the 2 x M4 CSSK screws, 2 x M4 nylock nuts and 2 x M4 penny washers that retain the
regulator to the top battery bracket and remove the regulator.
7.
Fit the new regulator using the 2 x M4 CSSK screws, 2 x M4 penny washers and 2 x M4 nylock
nuts.
8. Connect the solar positive wires to the S points on the regulator.
9. Connect the solar negative wires to the S points on the regulator.
10.
Connect the battery positive wires to the B point on the regulator.
11.
Connect the battery negative wire to the B point on the regulator.
12.
Reconnect the battery.
13.
Refit the battery top bracket into the solar unit using the 2 x M4 x 20 socket head cap screws
.
14.
Ensure the top O-ring is sitting correctly into the top casting. Refit the light head and tighten
the M6 x 20 socket head cap screws with the 4 x M6 nylon washers evenly.
DO NOT
OVERTIGHTEN.
Use the label to ensure correct location
of wires during assembly
SL10 AMP Regulator shown when
correctly fitted
+
+
-
-
