background image

sealey group, kempson Way, suffolk business park, bury st edmunds, suffolk. ip32 7aR

 01284 757500 

 01284 703534 

 [email protected] 

 www.sealey.co.uk

enViROnmenT pROTecTiOn

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to 
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely 
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids 
according to local regulations.

note

: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior 

notice.

important

: no liability is accepted for incorrect use of this product.

Warranty

: Guarantee is 12 months from purchase date, proof of which is required for any claim.

   fig.5

SJBeX200.V2, SJBeX300 | Issue 6 (2) 14/08/18

Original Language Version

© Jack Sealey limited

Summary of Contents for SJBEX200.V2

Page 1: ...setup is stable and secure before lifting Be careful of pinch points 9 This is a lifting device only Make sure the load is central on saddles before lifting 9 The beam can only be used to lift one end of the vehicle 9 ensure that there are no persons or obstructions beneath the vehicle before lowering 9 Always lower load slowly and carefully 9 When not in use store beam fully lowered 9 ensure all ...

Page 2: ...has two locking positions which are controlled by the locking lever 5 1 3 When jacking the locking lever will engage at certain heights approx 100mm and 240mm of lift height to prevent the jack from lowering all the way should the release valve be accidentally moved to lower the jack past this point you must raise the jack a small amount and then turn the locking lever clockwise whilst turning the...

Page 3: ...nd dispose of the jack and the oil according to local regulations 7 TROubLeshOOTing PRoBleM PoSSIBle CAUSe ReMedY Beam will not lift the load overloaded Be sure to use beam with adequate capacity oil level low Top up oil level Release valve not correctly closed Check and close release valve Air in system open release valve and pump the handle a few times Close valve and re try Piston rod not funct...

Page 4: ...duct becomes completely unserviceable and requires disposal drain any fluids if applicable into approved containers and dispose of the product and fluids according to local regulations note It is our policy to continually improve products and as such we reserve the right to alter data specifications and component parts without prior notice important no liability is accepted for incorrect use of th...

Reviews: