4. aSSembly
refer to parts diagram below.
4.1.
lay the sliding plate (8) onto the platform (1).
4.2.
connect the oil hose coupler (29) to the port on the hydraulic pump (20).
4.3.
connect air hose into the end of the air/manual pump (20).
4.4.
Attach the leading plate (9) to the end of the platform (1).
4.5.
insert safety handle (36) through detent on rear end of lift and screw into thread on the bracket on the end of the safety wire (37).
4.6.
tighten lock nut (35).
4.7.
Fit motorcycle wheel clamp (also see fig.1)
4.8.
fit crank handle assembly (40) to platform (1) through pre-drilled holes, use bolt (5) washer (38) and nut (7).
4.8.1.
fit moveable vice jaw (2) to crank handle assembly (40), use bolt (6).
4.8.2.
Fit fixed vice jaw (3) to platform (1), use bolt (5).
4.8.3.
fit stop plate (4) to platform (1), use bolt (5).
5. air Supply
5.1.
You will require an air pressure of minimum 120psi, maximum 200psi
to get the best performance from this lift.
WarNiNg!
ensure the air supply does not exceed 200psi while operating the lift. too high an air pressure and unclean air will shorten
the product’s life due to excessive wear, and may be dangerous, causing possible damage and/or personal injury.
5.2.
drain the air tank daily. Water in the air line will damage the lift.
5.3.
clean the air inlet filter screen weekly.
A
B
c
fig.1
mc680A | issue 3(i) 09/03/17
Original Language Version
© Jack sealey limited
