F R M - 1 0 1 0 I N S T R U C T I O N M A N U A L
11
Operation
Figure 9. Control Panel of FRM-1010
1.
Switch the circuit breaker to the "On" position.
2.
Turn Power, Heater, and Fan switches to the “On” position. Belts and conveyor will begin to move
simultaneously.
3.
Emergency Stop – Press the emergency stop to turn off the machine. In order to restart the
machine, you must release the emergency stop by turning the knob 120˚ clockwise.
4.
Adjust the conveyor speed.
5.
Adjust the temperature controller to the temperature desired to seal your material. Temperature
settings will vary based on bag material and thickness. If you are unsure what temperature setting
to use, we recommend starting at a low temperature (150ºC) and gradually increase to a
temperature that will seal your material. We highly discourage sealing material at a temperature
above 200ºC.
Please note: Temperature will be in Celsius, not Fahrenheit.
The
temperature controller cannot be displayed in Fahrenheit.
The PV value (red light) is the actual temperature and the SV value (green light) is the desired
temperature setting.
Figure 10. FRM-1010 Temperature Controller
Summary of Contents for Impresse FRM-1010
