60
7003338 - User Manual 65 Pro MD
6.3.8 Machine operation issues
Problem
Solution
The laminator will not turn on.
•
Check if the power cable is plugged into the wall outlet.
•
Check that the Stand-by switch is ON.
•
Make sure the main circuit breakers and machine circuit breakers are
flipped up or ON.
The motor will not run.
•
Make sure that the photo-eyes are not blocked.
•
Make sure that the Emergency Stop buttons were not activated. Rotate to
reset.
•
Turn the motor speed up.
•
Unplug the laminator and check the fuses. Only authorized safety or
maintenance personnel should do this.
The laminator is not heating up or
shows erratic temperature readings.
•
Make sure the heater is turned on in the heater screen on the EOI.
•
Make sure the rollers are together and turning at a moderate speed when
first heating up.
Images or Prints are rippling or
jumping as they are fed into the nip.
•
Apply tension to images or prints as they are fed into the nip. Hold cut
sheets back by hand.
The film output is rippled or wavy
(boat-waking)
•
Check that you have webbed the laminator correctly.
•
Improper film tension – most encapsulating films need a minimal amount
of brake tension.
•
Run the laminator at a higher speed for photo materials or heat-activated
prints because exposure to heat at low speeds can cause waving.
The film is cloudy or mottled.
•
Increase the roller temperature or decrease the motor speed.
•
Thicker films may require increased roller pressure due to the thicker
film layer.
6.3.9 Error Messages on the EOI
Error Messages
Cause
Solution
Critical error
•
Machine operation
is stopped
•
Cycle the machine power.
Non Critical error
•
Machine sub system
is disabled
•
Cycle the machine power to re-
enable the sub system.
Warning
•
Information only
•
Press the check mark to clear the
warning message.
Summary of Contents for 65ProMD
