Seal One 2200, User Manual

Page: 4 / 14

Display Description
The Seal One logo is shown on startup of the Seal One device. If the
logo remains permanently on the display during startup, the USB port on
your PC is most likely blocked or malfunctioning. In this case, please use
the supplied Micro-USB cable and / or another USB port on your PC.
If the problem persists and you are using a company PC, please contact
your System Administrator (the Seal One device might have to be spe-
cifi cally unlocked based on USB Vendor / Product ID).
The Seal One 2200 has established a USB connection to the PC, but
the Seal One companion application has not yet been started.
N.B. No CD is required to start the application.
For more information, please see section 4.1.1
The connection between Seal One 2200 and the internet is beeing esta-
blished.
N.B. The arrows are fl ashing.
The Seal One 2200 is connected to the internet and ready to use.
N.B. The dots on the arrows are running in opposite directions.
There is no connection between the Seal One 2200 and the internet.
Please check if you have an active connection to the internet. Maybe the
internet connection is blocked by a fi rewall.
Allow all incoming and outgoing Seal One connections.
Note: The warning sign is fl ashing.
The Seal One ID is needed to enroll with an acceptance partner. It will
show when you press and hold the authorize button for at least
3 seconds. As soon as your Seal One device is successfully registered, it
changes to the mode „ready to use“.
Note: In case you want to discontinue displaying the Seal One ID wit-
hout enrolling with a partner, push the button for at least 3 seconds once
more.
The Seal One 2200 device turns off after a few minutes of continued
inactivity.
If a transaction arrives while the device is in this state, the power
saving mode is automatically terminated and the transaction data is
shown.
For more information visit: https://www.seal-one.com/service
3 Symbols and their Meaning