YAK 52
.
Instruction Manual.
12
Machine screw M4x30mm.
Pushrod wire.
Switch.
Trim and cut.
150mm.
MOUNTING THE ENGINE.
2) Use a pin drill and 2mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
3) Use a drill to drill the four holes in the engine
mount rails.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
1) Position the engine with the drive washer
(150mm) forward of the firewall as shown.
7) Slide the throttle pushrod wire into the tube.
Position the engine between the mounts. Use
four M4x30mm machine screws to secure the
engine to the mount as shown.
5) Slide the pushrod tube in the firewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the firewall and
the fuel tank mount.
6) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor arm.
4.5mm.
Pushrod tube hole.
4mm.
