YAK 52
.
Instruction Manual.
32
1
2
3
C/A glue.
Epoxy.
50mm.
20mm.
M2x6mm.
3) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure and
glue the cockpit panel in place with C/A glue,
please see pictures as shown.
5) Install the canopy and secure it with M2x6mm
screws.
- Apply a bead of canopy glue around the inside
edge of the canopy. Position the canopy onto
the hatch. Use tape to hold the canopy secure
until the glue fully cures.
4) Position the canopy onto the fuselage. Trace
around the canopy and onto the fuselage using
a felt-tipped pen.
B
B
B
C/A glue.
C/A glue.
Cut.
INSTALLTION PILOT AND CANOPY.
2
1
3
M2x6mm.
2) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
1) Locate items necessary to install pilot,
cockpit panel, and canopy.
- Use scissors to trim the wing fillets.
- Glue both sides of the wing fillets to the
fuselage as shown.
