www.seagullmodels.com
7
1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the wing.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
4) Remove the two straps and the gear
wire. Drill four 1.5mm pilot holes into the wing
for the wood screws.
3) Using the two landing gear straps as
a guide, mark the locations of the four 3 x
15mm mounting screws onto the wing sur-
face.
5
) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 15mm wood screws.
The straps should be located equal dis-
tance from the inside and outside ends
of the wire.
Support
mounting block.
Support mounting
block possition.
Remove covering.
Machine screw 3 x 15 mm.
