5
5) Turn the wing panel over and delect the
aileron in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates
into both the aileron and wing panel.
6) Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the
aileron hinge area.
7) Repeat this process with the other wing
panel, securely hinging the aileron in
place
.
Install the lap control horn using the
same method as same as the aileron con-
trol horns.
8) Ater both ailerons are securely hinged,
irmly grasp the wing panel and aileron to
make sure the hinges are securely glued
and cannot be pulled out. Do this by care-
fully applying medium pressure, trying to
separate the aileron from the wing panel.
Use caution not to crush the wing struc-
ture.
Work the aileron up and down sev-
eral times to “work in” the hinges
and check for proper movement.
Note :
INSTALL THE AILERONS
CONTROL HORN.
Epoxy.
Fiberglass control horn
Fiberglass control horn
Ailerons control horn
INSTALL FLAP CONTROL HORN.
Epoxy.
Epoxy.
2
.
5
.
1
.
3
.
1
.
2
.
