15
.
INSTALLING THE ENGINE SWITCH.
Switch.
Trim and cut.
INSTALLING THE STOPPER
ASSEMBLY.
1) Using a modeling knife, carefully cut
of the rear portion of one of the 3 nylon
tubes leaving 1/2” protruding from the
rear of the stopper. his will be the fuel
pick up tube.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
Switch.
B
A
3
.
1
.
2
.
1
.
2
.
3) Carefully bend the second nylon tube up
at a 45º angle. his tube is the vent tube.
4) Test it the stopper assembly into the tank.
It may be necessary to remove some of the
lashing around the tank opening using a
modeling knife. If lashing is present, make
sure none falls into the tank.
3
.
Vent tube.
Fuel ill tube.
Fuel pick up tube.
