WWW.SEAGULLMODELS.COM
17
5) Attach the speed control to the side of
the motor box using two-sided tape and tie
wraps. Connect the appropriate leads from
the speed control to the motor. Make sure
the leads will not interfere with the operation
of the motor.
Recomend Mounting Speed Control in-
side Fuselage If Flying off Water.
INSTALLING THE SPINNER.
Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a sharp mod-
eling knife and carefully trim away the spinner
cone where the propeller comes in contact with
it.
INSTALLING AILERON SERVOS.
Because the size of servos differ, you may
need to adjust the size of the precut opening in
the mount. The notch in the sides of the mount
allow the servo lead to pass through.
1) Using a small weight (Weighted fuel pick-
up works well) and string, feed the string
through the wing as indicated.
2) Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole locations
on the blocks.
17
Speed control.
Battery.
