WWW.SEAGULLMODELS.COM
13
MOUNTING THE ENGINE
1) Position the engine with the drive
washer (145mm) forward of the firewall as
shown.
2) Use a pin drill and 4mm drill bit to drill
a small indentation in the mount for the en-
gine mounting screw.
4 mm
3) Use a drill to drill the four holes in the
engine mount rails.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
7) Slide the throttle pushrod wire into
the tube. Position the engine between the
mounts. Use four M4x30mm machine
screws to secure the engine to the mount as
shown.
5) Slide the pushrod tube in the firewall
and guide it through the fuel tank mount.
Use medium C/A to glue the tube to the fire-
wall and the fuel tank mount.
6) Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the car-
buretor arm.
Pushrod
13
150 mm
4.5 mm
4x30 mm.
