ET6.
Instruction Manual.
8
2) Locate the two nylon control horns, two
nylon control horn backplates and four
machine screws.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
2mm X 20mm.
6) Connect the linkage as shown and se-
cure the control wire with a wire keeper.
AILERON LINKAGE.
1) Using a ruler & pen to draw a straight
line as below picture.
Control Horn.
Mounting Screws.
Mounting Plate.
5
)
Mount the control horns by inserting the
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
Servo arm.
Wire keeper.
Straight line.
Pen.
Cut
.
