Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
Pushrod wire.
Control horn.
Repeat the procedure for orther wing
haft.
!
1)
Locate and cut out the covering film
from the servo holes in both sides of fuselage.
FUSELAGE SERVO INSTALLATION.
INSTALLING THE SWITCH.
Install the switch into the precut hole in the
side, in the fuselage.
!
3) Secure the servos with the screws pro-
vided with your radio system.
!
2) Install the rubber grommets and brass
collets onto the elevator servo. Test fit the
servo into the elevator servo mount.
HORIZONTAL STABILIZER.
!
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
C/A glue.
Control horn.
!
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal sta-
bilizer ( both side of fuselage).
!
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
Right side.
Remove covering.
Elevator servo.
Right side.
Center line.
Left side.
Rudder servo.
Switch.