AILERON SERVOS-LINKAGES.
!
1) Install the metal connector onto servo
arm as same as picture below.
!
2) Turn the wing panel right side up. Using
a modeling knife, remove the covering at servo
tray.
Attach the thread to the servo lead and
carefully thread it though the wing.
!
3)Secure the servos with the screws pro-
vided with your radio system.
!
6) Reinstall the gear wire and install the
straps using the four 2 x 12mm wood screws.
Tighten the screws completely to secure the
gear wire in place.
Install the rubber grommets and brass collets
onto the aileron servo. Test fit the servo into
the aileron servo mount.
Attach the micro control connector to the
servo arms. Be sure to use the lock tie but it
could free rotation .
Lock tie.
!
4) Insert aileron control horn to the aileron.
as same as picture below.
2 x 12mm.
Landing gear wire.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
Control horn.
Wing bottom.
Aileron control horn slot.
Control horn.