12
Fig. 7
The arrow on the regulator shows the direction of the gas flow. The pressure
regulator must be mounted horizontally to ensure proper preset outlet
pressure. If the regulator is installed in any other position, the outlet pressure
must be reset for proper operation.
A leak limiter is supplied with every regulator to allow excess gas pressure to
escape. Do not obstruct leak limiter on gas pressure regulator, as
obstruction may cause regulator to malfunction.
WARNING:
PRIOR TO LIGHTING, CHECK ALL JOINTS IN THE GAS
SUPPLY LINE FOR LEAKS. USE SOAP AND WATER SOLUTION. DO NOT
USE AN OPEN FLAME.
After piping has been checked for leaks, all piping receiving gas should be fully
purged to remove air.
Before operation, verify thermocouple is securely seated in the safety valve.
The thermocouple should be tightened a
1
/
4
turn past finger tight.
DO NOT
OVERTIGHTEN.
Over-tightening may damage the thermocouple or safety
magnet.
