Seagate BARRACUDA 2LP, Product Manual

Page: 19 / 102

Barracuda 2LP Product Manual, Rev. D 9
4.4 Installation
For option jumper locations and definitions refer to Section 10.1. Drive default
mode parameters are not normally needed for installation. Refer to
Section 11.3.2 for default mode parameters if you need them.
• Ensure that the SCSI ID of the drive is not the same as the host adapter.
• If multiple devices are on the bus, set the drive’s SCSI ID to one that is not
presently used by other devices on the bus.
• If the drive is the only device on the bus, attach it to the end of the SCSI
bus cable. Internal termination is available on ST31250N, ST31250W,
ST32550N, and ST32550W drives by enabling this feature with a jumper
(see Section 10.1).
External terminators are required for ST31250ND, ST31250WD,
ST31250WC, ST31250DC, ST32550ND, ST32550WD, ST32550WC,
and ST32550DC drives. These external terminators must be provided by
the user, systems integrator, or host equipment manufacturer.
• If you attach the drive to a bus that contains other devices, and the new
drive is not attached to the end of the bus, remove termination from the new
drive.
• Set all appropriate option jumpers prior to applying power to the drive. If
you change jumpers after applying power, recycle the drive’s power to
make the new settings effective.
Formatting
• It is not necessary to low-level format this drive. The drive is shipped from
the factory low-level formatted in 512-byte sectors.
• Reformat the drive if:
a. You select a different sector size.
b. You select a different spare-sector allocation scheme.