Revision 22 13.10
8
DOOR CLEARANCE
Allow 7” (18 cm) of clearance on the right side of the machine for the door to open and extend past the cabinet side. See
also the clearance requirements in Section 2 for refrigerated units.
LOADING PRODUCTS
To present your product in as an attractive and professional manner as possible, do not load any damaged items, and
make sure items are facing forward for easy identification by your customer.
Note: The size of the item being vended must be larger than the Helix Coil, but smaller than the Product Column to vend
correctly. Never force an oversized item into the Helix Coil or Product Column, nor attempt to vend an item that is smaller
than the Helix Coil as this will create problems and deter customers. (Fig.5)
1. To Load Product:
A.) Push down and hold the release latch located on the right side of the tray and slidel the desired Product Tray
toward you, all of the way forward. Product Tray will tilt down or can be removed and placed on the floor or a
table.
Note: Pull out only one (1) Product Tray at a time. Beverage trays do not tilt for loading!
B.) Place product in proper size Helix Coil. Note: Bottom of product must
rest on the Product Tray and not on the Helix Coil. (Fig. 5) Load each
Product Chute from front to back. Note: Do not leave any spaces between items.
C.) Once Product Tray is loaded, lift the front of the tray to level and push it
back in. Repeat above steps until all Product Trays are fully loaded.
D.) After loading the product, if you have removed the tray to do so, place the
Tray in the cabinet by aligning the wheels in the guide rails. Clear the wire harness
To the side so that it is not interfering with the tray below.
To increase the length of the Helix Coil, plastic Product Pushers can be snapped on the end. Product Pushers can be
purchased from Seaga’s Customer Care team.
Note
: We suggest that you always partially fill the vendor with product and perform at least five (5) test vends. Test vends
can be performed easily by entering Service Mode and using the Diagnostics/Motors to select the selection to test.
Fig. 5 – Loading Helix Coils
Correct – load
product
between Helix
Coils, resting
on the product
tray.
Helix Coil
Product Tray
Columns
Incorrect
Incorrect
Incorrect
Correct – load product between coils,
resting on the product tray.
