Website: www.seada.co.uk
24 / 47
E-mail: [email protected]
4. Network Connection
4.1 Connecting Mode
Direct connection:
Connect the camera and computer by network connecting
cable.
Internet connection mode:
Connect the camera to Internet by Router or Switch
and user can log in the device by browser.
Note: Please do not put the power and network cable in places where can be
easily touched to prevent video quality lowered by unstable signal
transmission due to poor contact of cables.
The computer must have the network segment where the camera IP address
belongs to. The device will not be accessible without the segment. I.E. The camera
default IP address is 192.168.5.163, then segment 5 must be added in the
computer. Specific steps are as below:
Firstly,
open the window of Local Area Connection Properties on computer, select the “Internet protocol version 4(TCP/IPv4)”
as shown by picture on the left. Double click or click the property “Internet” protocol version 4 (TCP/IPv4) to enter into the
Internet Pro
tocol Version 4(TCP/IPv4) Properties window, select “Advanced” to enter the Advanced TCP/IP Setting and add
IP and subnet mask in the IP browser as picture shown below. Click the “Confirm” to finish the adding of IP segment. User
can add the corresponding network segment according to the revised IP address of the camera.
Note: The IP address to be added cannot be same with that of other computers or devices. The existence of this IP
address needs to be verified before adding.
