MANUAL SELF-LEARNING
International registered trademark n. 2.777.971
Switch-off the main power, release the operator and manually position the gate at mid-travel.
Then restore the mechanical lock and the power supply.
With the gate at mid-travel, access the menu-9 PROGRAMMING
select ON to start the self-learning cycle and the gate will perform: CLOSE - OPEN - CLOSE
during cycle, to store the POINTS of STOP, press or or (if transmitters have already been
stored) at every point of mechanical stop of the gate. The self-learning is done
C) THROUGH IMPULSES
A
Gate at mid-travel
B
Closed gate
C
Gate in opening movement
Gate completely open
OK
MENU
SEA
SET
ON
MENU
SEA
SET
9
PROGRAM-
MING
UP
Press or to set the point of STOP in closing
D
Gate in closing movement
Gate completely closed
!
If the motor starts in opening, see the
* REVERSE MOTOR FUNCTION
on previous page
WARNING: The following procedure is potentially dangerous and should
only be performed by qualified people and in safety conditions
!
OK
MENU
SEA
SET
ON
MENU
SEA
SET
9
PROGRAM-
MING
UP
DOWN
the gate performs the cycle:
CLOSE - OPEN - CLOSE
UP
Press or to set the point
of STOP in opening
UP
Press or to set the point
of STOP in closing
15