SEA SLIDE DG R2F, Manual, Page: 13 / 32

SET DESCRIPTION DEFAULT
SET
VALUE
Closing
If activated, the photocell reverses the
movement in closing; during the pause, it
prevents the reclosing
Opening
If activated, it blocks the movement in opening ;
when released, the opening movement continues
Stop
If the photocell is activated before the Start input,
the Start will be ignored. If activated after the
Start input, the photocell will be ignored. If
activated during closing, the gate will reopen
Stop and close
In closing, the photocell stops the movement until
it is occupied; when released the closing
movement continues
Close
The photocell stops the gate until it is occupied in
both opening and closing; when released, it gives
a closing command (it closes 1 s after its release)
Pause reload
If activated, the photocell recharges the time of
pause during pause. In closing it reverses the
movement
Shadow loop
Until occupied, with open gate, it pre- vents
reclosing. It is Off during closing
Delete pause time
If activated in opening, pause or closing, the gate
reopens completely and closes without observing
the pause time
Opening and closing
Active in opening and closing
Only opening Active only in opening
Only closing Active only in closing
Automatic Limit switch in automatic recognition
Only opening Active limit-switch in opening only
Only closing Active limit-switch in closing only
106 DIAGNOSTICS 1 10 Shows last event (See alarms table) - - - -
107 MAINTENANCE CYCLES 100 240000 Setting from 100 to 240000 100000
108 PERFORMED CYCLES 0 240000
Reports the executed cycles. Keep pressed OK to
reset the cycles
0
112 PASSWORD - - - -
Allows the entering of a password blocking the
control unit parameters modification
- - - -
120 BASIC MENU
Press OK to exit the special menu.
The special menu switches off automatically after 20 minutes
Note 1: The * indicates that the default value or the menu may change depending on the selected motor type.
Note 2: After initialization the parameters "motor type" and "limit switch type" remain on the value chosen in the setup
program.
Note 3: Display writing speed set on 30% keeps writing slow; Display writing speed set on 100% keeps writing fast. Please note
that speed does not change on JOLLY 3 display.
MENU SP
104
SELECT LIMIT SWITCH
Automati
c
102
SECURITY EDGE 1
DIRECTION
Opening
and
Closing
97 PHOTOCELL 1 Closing
13